IPad Air Charging Problem Jumper Ways Solution

IPad Air Charging Problem Jumper Ways Solution

Apple iPad Air Not Charging problem like there is No Charging indication shows on the display when the battery charger is being a plug-in.
This problem is may cause by a faulty charger or faulty components on iPad Air PCB board. This problem may sometimes happen if the device suffered wet or water damaged or just exist.

Ensure that the battery and the battery charger are in good working condition.

1. Check all the components shown in the image below, you may start by checking the USB pin connector.
2. Then the fuse, diode, capacitors and filter coil for possible open or short circuit.
3. Trace each of the connect.

Now re-solder charging connector pins and check.

Check charging voltage with the help of a multimeter. Place Negative terminal of the multimeter on ground and Positive on a charging pin (1st pin from your left-hand side).

Make sure that the voltage is between 5V to 5.5V, if it is not then replaced charging connector.

All of the above steps will surely help you to resolve your iPad Air charging problems in the best possible manner. If you are lucky enough then simple workaround method will get the job done for you.